mywatergarden

water spout

Build a "water spout" like the one pictured below? then we will show you how.

 

First a whole is dug and the tank installed to act as the reservoir

A breeze block wall, 2 bricks wide was also then built, and rendered

 

Next the liner and hose for the water spout was fitted. Why so much liner?

see the JW fountain rule

Then the "water spout" and wire mesh were fitted, along with the pump. (As we used such a big tank copper pipe was laid across it to give support)

Then the decorative gravel was added and the pump switched on (see top picture)

 

The pipe from the pump comes in through the bottom of the wall and back out higher up. Do not put any joints in the pipe as this will reduce the flow, the pipe in the picture is longer than need be to make the picture clearer

 

 

Yes, the Lions head is nice, but it is no longer made, so please do not ask where we got it.

For pumps click here

Hit Countersince 21 10 06

0 21/10/06 42 07 01 07

 

 

Home  Questions  search  projects   Tips   CONTACT US    page missing?

If this was helpful, please leave a comment in our  Guestbook

Due to a technical glitch, ALL hit counters were set to 0 on 9/05/08

copyright,2001- 2008 mywatergarden.co.uk

mywatergarden.com